LATEST NEWS.
RM125X Decal sets

A short video of me racing EVO class on 29 July 07.
Right click to play.

Star of the month.

Craig Taylor and his X

Stolen Bikes

Click the picture to go to my youtube page.

Check out the decal page

The RM125x 1981 was the original design of the 3 similar models spanning 1981 1982 and 1983. It was the only one to have case reed induction. Both other RM125’s had full reed induction.

The 1983 RM125D had yellow forks and adjustable rear suspension compression damping.

This is what a 1981 RM125x engine looks like, it has case reed induction as against 82 83 which had full reed induction therefore the cylinder and cases are different and not interchangeable with 82 83. Pictures supplied by Jason Ladson from Australia. Click on each picture to enlarge.

Did you know that the airbox on the D model was enlarged to allow greater airflow. The way to tell is to look at the box from the carb hole side. The 81 RM125x and 1982 RM125d boxes are U shaped but the 1983 RM125d boxes are squared off across the top to make the center section of the box larger and allow greater air flow. All boxes fit all model years as the mountings and the physical size are the same.

Did you also know that the radiator is slightly different for the 1981 RM125x compared to the 1982 and 1983 RM125Z and D. They are all the same size and fit all years but the outlet at the top of the Z and D model is slightly angled to fit the Z and D cylinder head whereas the X model outlet points straight down to align with the X cylinder head outlet.

Most people think that the 3 RM125 1981 1982 and 1983 model years had the same frame but they were all slightly different. The 81 and 82 are interchangeable but the 83 RM25d had the bell crank pivot set 20mm rearwards. and a different swing arm. If you use an RM125x frame with an RM125d swing arm you will alter the Full Floater ratio. It will work but not as Suzuki intended.

Below are the three cranks from an X Z and D. The X is the first picture.
You can see that the holes are different sizes. This affects the weight and if the cranks are swapped between the years will affect engine characteristics. They all measure the same dimensions so are interchangeable.

Below is the Z crank with medium holes and medium weight.

Below is a crank from a 1983 D with the smallest holes and heaviest weight.